1 part cement 2 parts sand and 4 parts gravel.
Chain link fence installation method statement.
Method statement installation of fencing and gate 1 0 objective of procedure this work method statement covers the fencing works for your project name.
Chain link fabric height 2 depth of post in ground total post height.
Galvanized steel is the strongest mesh.
Installation of chain link fence works to comply with schedule of finishes the general architectural.
Method statement installation of fencing and gate 1 0 objective of procedure this work method statement covers the fencing works for your project name.
Simply push the post into the cement mix in the center of the hole.
Civil specifications for the project and owner engineer requirements.
The scope of this method of statement is to cover the demolishing methodology of the following.
Terminal posts should be set 2 higher than the width of the fabric and line posts 2 lower than the fabric width.
Leave the concrete a few inches below ground level.
Slope it away from the post to help with water runoff.
Run a tension bar through the links at the end of the mesh.
Make sure the mark you made earlier is at ground level.
Set the terminal posts in concrete using a concrete mix as follows.
Most chain link posts can be installed by actually pouring the cement in the hole first and then sticking the post in the wet cement.
This item shall consist of furnishing and erecting fencing and gates in accordance to the specifications and the details shown on the drawings or as directed by the e r.
Set line posts approx.
Chain link fabric or mesh is usually sold in rolls 4 5 or 6 feet high.
The bar makes the end of the fence rigid and provides something to attach to the posts.
If using fast set concrete pour the dry mix around each post to a few inches below ground level and add water.
Initially the water will sit on top but eventually will work its way to the bottom.
This will incude all the work procedures and instruction that are made by the she and kusile specifications scope this method statement will apply to the instalation of the 2 4 high welding mesh sercurity fence as per drawing supplied by eskom kusile.
The purpose of this method statement is to illustrate how the existing fence and shelters will be removed from site in proper and safe way.
Add gravel to the bottom of the post hole for drainage.
Mix a fairly heavy solution as too much water weakens concrete and may cause cracking.
Lay the chain link mesh on the ground outside the fence.
This item shall consist of furnishing and erecting fencing and gates in accordance to the specifications and the details shown on the drawings or as directed by the e r.
Set terminal posts as tight to the string as possible without touching the string.
Set the line post in place against the layout line adjust it for plumb and temporarily support it in place with braces.
